CyclePro Freewheel vise Freewheel Tool
Main Photo
Name: CyclePro Freewheel vise Freewheel Tool
Brand: CyclePro
Category: Freewheel Tool
Model: Freewheel vise
Country: United States
Added By: ovalle on 01/19/12
Updated By: ovalle on 01/19/12
Additional Photos - click for full size
General Information
The freewheel vice is used to disassemble a freewheel. The large sprocket is secured by the vice and a chainwhip is used to remove the smaller sprocket, allowing the replacement of worn or damaged individual sprockets.

Tool is marked "CyclePro (R) USA", bar is 25mm x 7.5mm x 30cm long with 6mm wide slot that starts 58mm from the end and is 105mm long (c-c). Pegs are 12.5mm diameter x 15mm with a groove intended to next into the cogs. The peg in the slot has a knurled nut on the back side that allows repositioning along the slot.

Found at the bottom of my old tool box and identified thanks to Mark Bulgier at the Classic Rendezvous google group. 

Additional Resources
Marketplace:Looking to buy one of these?Sell one like this
Resources:Reference & Charts
User Comments
Required
  Loading Comments

VeloBase v.2.8.0 - a Fischer Frameworks application, Copyright ¬© (2021) - All rights reserved.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Find the information on useful? Please consider donating a few dollars towards the web-hosting cost. Thank you.